1. For the child to be in the correct M-position (frog-leg position) in the baby carrier, the seat width must always extend from the back of one knee to the back of the other. The width of the seat should be adjusted before putting the carrier on. A good rule of thumb is that the seat width should be approximately half the baby's body length. Adjust it to the individual baby's build. Regularly check that the seat width still corresponds to the baby's size and widen it if necessary.

2. Put the pre-set baby carrier around your neck with the straps facing outwards.

3. Close the buckle until it clicks clearly into place. Tighten the hip belt.

4. Place the baby on the hip belt at head-kissing height. The seat width should extend from the back of one knee to the back of the other.

5. Lift the back panel...

6. ... and place the straps on your shoulders. Support your baby alternately with one hand.

7. You now have both shoulder straps hanging straight down.

8. Reach under the first support beam and grasp the one opposite it. Pull it diagonally downwards.

9. Repeat this on the other side. Do you switch hands and hold Now hold your baby in the hand where you have the first carrier.

10. Now you have You hold both straps in your hands.

11. Guide the straps forward under the baby's legs.

12. Now hold the straps in front under your baby's bottom.

13. Tie a double knot under the baby's bottom. (Alternatively, you can cross the straps under the baby's bottom, bring them back under the baby's legs, and...) (Make a double knot there.)

14. Check if everything is in the right place: - Is your mouth and nose clear? - Is the mask fastened tightly enough? - Is the back high enough? - Are the straps well spread across the shoulders and back? - Is it at head-kissing height?